orangejuice2
(Package: qcc) :
Orange juice data -- Part 2
A full description of the problem is given in orangejuice .
● Data Source:
CranContrib
● Keywords: datasets
● Alias: orangejuice2
●
0 images
|
boiler
(Package: qcc) :
Bolier temperature data
Temperature readings from the eight configured burners on a boiler.
● Data Source:
CranContrib
● Keywords: datasets
● Alias: boiler
●
0 images
|
pistonrings
(Package: qcc) :
Piston rings data
Piston rings for an automotive engine are produced by a forging process. The inside diameter of the rings manufactured by the process is measured on 25 samples, each of size 5, for the control phase I, when preliminary samples from a process being considered 'in control' are used to construct control charts. Then, further 15 samples, again each of size 5, are obtained for phase II.
● Data Source:
CranContrib
● Keywords: datasets
● Alias: pistonrings
●
0 images
|
circuit
(Package: qcc) :
Circuit boards data
Number of nonconformities observed in 26 successive samples of 100 printed circuit boards. Sample 6 and 20 are outside the control limits. Sample 6 was examined by a new inspector and he did not recognize several type of nonconformities that could have been present. Furthermore, the unusually large number of nonconformities in sample 20 resulted from a temperature control problem in the wave soldering machine, which was subsequentely repaired. The last 20 samples are further samples collected on inspection units (each formed by 100 boards).
● Data Source:
CranContrib
● Keywords: datasets
● Alias: circuit
●
0 images
|
orangejuice
(Package: qcc) :
Orange juice data
Frozen orange juice concentrate is packed in 6-oz cardboard cans. These cans are formed on a machine by spinning them from cardboard stock and attaching a metal bottom panel. A can is then inspected to determine whether, when filled, the liquid could possible leak either on the side seam or around the bottom joint. If this occurs a can is considered nonconforming. The data were collected as 30 samples of 50 cans each at half-hour intervals over a three-shift period in which the machine was in continuous operation. From sample 15 used a new bacth of cardboard stock was punt into production. Sample 23 was obtained when an inexperienced operator was temporarily assigned to the machine. After the first 30 samples, a machine adjustment was made. Then further 24 samples were taken from the process.
● Data Source:
CranContrib
● Keywords: datasets
● Alias: orangejuice
●
0 images
|
pcmanufact
(Package: qcc) :
Personal computer manufacturer data
A personal computer manufacturer counts the number of nonconformities per unit on the final assembly line. He collects data on 20 samples of 5 computers each.
● Data Source:
CranContrib
● Keywords: datasets
● Alias: pcmanufact
●
0 images
|
dyedcloth
(Package: qcc) :
Dyed cloth data
In a textile finishing plant, dyed cloth is inspected for the occurrence of defects per 50 square meters. The data on ten rolls of cloth are presented.
● Data Source:
CranContrib
● Keywords: datasets
● Alias: dyedcloth
●
0 images
|